3dprinters
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
3dprinters [2014-12-02 16:28] – tim | 3dprinters [2023-05-16 17:41] – simon | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== 3D Printers ====== | ====== 3D Printers ====== | ||
+ | |||
+ | === Original Prusa i3 MK3s === | ||
+ | < | ||
+ | Ownership: Miron Zadora\\ | ||
+ | Status: Gone.\\ | ||
+ | Location: Not here\\ | ||
+ | Filament: 1.75 mm | ||
+ | |||
+ | === Ultimaker 2 === | ||
+ | [[ultimaker2|Ultimaker 2]]\\ | ||
+ | Ownership: Hacklab. Bought December 2014.\\ | ||
+ | Filament: 3.00/ | ||
+ | |||
+ | === Voron 2.4r2 === | ||
+ | [[voron_2_4_r2|Voron 2.4 r2]]\\ | ||
+ | Ownership: jacob Lewis\\ | ||
+ | Status: Being tuned, but works\\ | ||
+ | Location: G11\\ | ||
+ | Filament: 1.75 mm\\ | ||
+ | |||
+ | ====== Approved filaments ====== | ||
+ | |||
+ | Be careful as our printers use different diameter filament! | ||
+ | |||
+ | Most of these can be bought on amazon.\\ | ||
+ | You can also try asking on the mailing list as some members may be willing to sell some of their own. | ||
+ | |||
+ | ==== PLA ==== | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | |||
+ | ==== PETG ==== | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | |||
+ | ====== Old 3D printers ===== | ||
=== 3D RepRap === | === 3D RepRap === | ||
Line 16: | Line 55: | ||
Ownership: unclear\\ | Ownership: unclear\\ | ||
Work in progress. Needs firmware reloaded and motor connectors put onto the cables. | Work in progress. Needs firmware reloaded and motor connectors put onto the cables. | ||
- | |||
- | === Ultimaker 2 === | ||
- | Ownership: Hacklab. Bought December 2014. | ||
3dprinters.txt · Last modified: 2024-02-06 19:25 by jaso55555