3dprinters
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
3dprinters [2018-09-06 19:46] – DavidW | 3dprinters [2018-09-06 19:49] – [3D Printers] DavidW | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== 3D Printers ====== | ====== 3D Printers ====== | ||
- | |||
- | === 3D RepRap === | ||
- | [[http:// | ||
- | Ownership: Matt Ellis\\ | ||
- | RAMPS 1.2 board, the electronics board that controls the printing process.\\ | ||
- | Location:in the store, \\ | ||
- | Status: semi-working, | ||
- | |||
- | === Maker Bot === | ||
- | Ownership: < | ||
- | Status: Currently not working, (worked before)\\ | ||
- | Extruder isn't working and the firmware on it is the wrong one. Needs loads of work. | ||
=== Original Prusa i3 MK 2 === | === Original Prusa i3 MK 2 === | ||
+ | [[Prusa i3 MK 2]]\\ | ||
Ownership: David Weis\\ | Ownership: David Weis\\ | ||
Status: Work in progress.\\ | Status: Work in progress.\\ | ||
- | See [[Prusa i3 MK 2]] | ||
- | |||
- | === Prusa Style === | ||
- | Ownership: unclear\\ | ||
- | Work in progress. Needs firmware reloaded and motor connectors put onto the cables. | ||
=== Ultimaker 2 === | === Ultimaker 2 === | ||
Line 33: | Line 17: | ||
* [[https:// | * [[https:// | ||
* [[https:// | * [[https:// | ||
- | * RS Pro | + | * [[https:// |
* [[https:// | * [[https:// | ||
* [[https:// | * [[https:// | ||
Line 40: | Line 24: | ||
* [[https:// | * [[https:// | ||
* [[https:// | * [[https:// | ||
+ | |||
+ | ====== Old 3D printers ===== | ||
+ | |||
+ | === 3D RepRap === | ||
+ | [[http:// | ||
+ | Ownership: Matt Ellis\\ | ||
+ | RAMPS 1.2 board, the electronics board that controls the printing process.\\ | ||
+ | Location:in the store, \\ | ||
+ | Status: semi-working, | ||
+ | |||
+ | === Maker Bot === | ||
+ | Ownership: < | ||
+ | Status: Currently not working, (worked before)\\ | ||
+ | Extruder isn't working and the firmware on it is the wrong one. Needs loads of work. | ||
+ | |||
+ | === Prusa Style === | ||
+ | Ownership: unclear\\ | ||
+ | Work in progress. Needs firmware reloaded and motor connectors put onto the cables. | ||
+ |
3dprinters.txt · Last modified: 2024-02-06 19:25 by jaso55555