Differences

This shows you the differences between two versions of the page.

--- 3dscanner [2015-07-23 21:10] – created miek
+++ 3dscanner [2016-12-13 23:40] – [Log] martin
@@ Line 1: / Line 1: @@
 ====== 3D Scanner ======
-We have a NextEngine 3D Scanner SD.
+We have a NextEngine 3D Scanner SD. Status: broken
 ===== Software install =====
-  - Download ScanStudio CORE 1.7.3 from www.nextengine.com/start and save to computer
+  - Download ScanStudio CORE 1.7.3 from www.nextengine.com/start and save to computer. (local mirror: {{:private:scanstudio_1.7.3.exe}})
-  - Download the Desktop 3D scanner drivers from support.nextengine.com and go to the download section and install
+  - Download the Desktop 3D scanner drivers from support.nextengine.com and go to the download section and install. (local mirror: {{:private:usb_driver_installer.exe}})
   - After save is complete, right click in installer and go to Properties
   - Then click on the Compatibility tab and check 'Run this program in compatibility mode for:" and set it to Windows XP SP3 and press OK
@@ Line 12: / Line 12: @@
   - Proceed to install and make sure that the 3D Scanner driver box is unchecked (if it is checked, then proceed and just ignore the errors that might pop up)
   - ScanStudio will start with errors, but just close the software after it loads up
-  - Copy the attached DLL (wdapi901.dll) to the following directories:
+  - Copy the attached DLL ({{:private:wdapi901.dll}}) to the following directories:
           * C:\Program Files(x86)\NextEngine\ScanStudio\Driver
           * C:\Program Files(x86)\NextEngine\ScanStudio\DLL
@@ Line 18: / Line 18: @@
 If installing on a 32-bit PC, please skip steps 7-9
+==== Log ====
+-11-18:
+  * Laura & Random reported that the machine seemed to be broken
+-1-28:
+  * Mike opened it up and found that there is an unknown fault on the power supply board - similar to its initial fault.
+-12-13:
+  * Martin has fixed the power supply fault.