denfordnovamill
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionNext revisionBoth sides next revision | ||
denfordnovamill [2016-10-06 15:48] – created tim | denfordnovamill [2018-01-11 12:07] – tkerby | ||
---|---|---|---|
Line 2: | Line 2: | ||
{{ : | {{ : | ||
+ | |||
+ | ===Training Courses for Schools (Denford)=== | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | ===CNC Use Notes (incomplete)=== | ||
+ | ==@ The CNC machine== | ||
+ | * Open VR Milling v5 | ||
+ | * (If you are introducing a new tool) New tool-> Post Processor -> Number = The variable you have used at the post-processing stage of the Fusion 360. Enter a small description of the tool | ||
+ | * Turn red switch to turn on the machine (It is below the desk) | ||
+ | * (For wood) Use special vice. | ||
+ | * Select vice rouch selection of clamping. | ||
+ | * Attach vice fasteners on bed and vice. The connecting material ideally should be parallel with the earth maybe slightly higher on the screw side | ||
+ | * Then press vice grip of wood with the screws | ||
+ | * Home - xyz -> Jog (to the the offset | ||
+ | * Arrow keys allow you to move around the endmill position | ||
+ | * Set override to 100% with knobs. | ||
+ | * Down left -> Set offsets -> Tooling ?? -> Set tool | ||
+ | * For one tool don’t set diameter etc. This is not the case if you have multiple endmills | ||
+ | * Click change tool | ||
+ | * Attach the holder to the machine: | ||
+ | * Remove the cap | ||
+ | * Unscrew screw | ||
+ | * The fastener should go at the middle of the opening | ||
+ | * Clean holder& slot before attaching it | ||
+ | * Work offsets (Find ‘0’ point) | ||
+ | * For low precision you need to start the spindle and jog it as soon as it is cutting | ||
+ | * Control panel -> Job -> Set spindle speed -> Hit play | ||
+ | * Tool & offset -> Set X or Y | ||
+ | * Add half the diameter of the tool | ||
+ | * Check the value @ the control panel | ||
+ | * For z do the same | ||
+ | * File -> Open -> Select the fnc file | ||
+ | * Control - Auto | ||
+ | * Close water pump so that only air comes out | ||
denfordnovamill.txt · Last modified: 2019-01-20 15:05 by mike