door_access_controllers
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| door_access_controllers [2020-08-13 17:51] – tim | door_access_controllers [2020-08-16 16:35] – [Version 1] tim | ||
|---|---|---|---|
| Line 132: | Line 132: | ||
| Cable colours in Hacklab installations: | Cable colours in Hacklab installations: | ||
| - | ^ Pin ^ G1/G2/G8 ^ G11 (and photos) ^ | + | ^ Pin ^ G1/G2/G8 ^ G11 (and photos) |
| - | | GND | blue | blue | | + | | GND | blue | blue | black | |
| - | | VCC | green | orange | | + | | VCC | green | orange | red | |
| - | | RST | brown | brown | | + | | SDA | orange | green | yellow |
| - | | SDA | orange | green | | + | | SCL | white-green | white-green | blue | |
| - | | SCL | white-green | white-green | | + | | RST | brown | brown | green | |
| - | | LED +ve | white-brown | white-brown | | + | | LED +ve | white-brown | white-brown |
| - | | Piezo | white-blue | white-blue | | + | | Piezo | white-blue | white-blue |
| The LED should be connected between LED and GND, with a 120R series resistor. To avoid damaging the LED, use hot-melt glue to secure it in place (not cyanoacrylate). | The LED should be connected between LED and GND, with a 120R series resistor. To avoid damaging the LED, use hot-melt glue to secure it in place (not cyanoacrylate). | ||
door_access_controllers.txt · Last modified: 2023-04-08 10:24 by tim