g14_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
g14_setup [2019-07-03 22:57] – [Tasks] tim | g14_setup [2019-08-10 17:56] – [Tasks] tim | ||
---|---|---|---|
Line 5: | Line 5: | ||
These tasks can be started now: | These tasks can be started now: | ||
- | * Order door-closed sensor | + | * Install shelf for PCB etch tank |
- | * Order/ | + | * < |
+ | * Shelves | ||
+ | * <del>Order/ | ||
+ | * Run 4 cat5 cables from G11 rack to G14 roof space | ||
+ | * Sort/ | ||
+ | * Clean ESD mats and trim to match worktops | ||
+ | * < | ||
+ | * < | ||
+ | * Obtain some chairs (3-4, computer operator chairs or " | ||
- | ===== Access control | + | ===== Shelves |
- | The door will be fitted with the same type of lock as used for G2 and G8. The lock is currently | + | The vertical brackets are installed but we will need to order more horizontals, |
- | ===== Floor ===== | + | On the narrow end of the room, above the component drawers: |
- | The floor has damage that will need to be filled. Then it can be painted or covered with vinyl (this is a more practical task than for G1 as the space is small and already empty). | + | * 3 of 226cm x 30-31cm |
- | ESD flooring has been proposed but is likely to be expensive. We have a roll of ESD flooring but it is soft (anti-fatigue, | + | To the left of the window: |
- | ===== Networking ===== | + | * 150cm x 54cm (for the function generator and HP power supply) |
+ | * 150cm x 25-30cm (for oscilloscope, | ||
- | Cables will be run from the server rack in G11 (2-4 would be appropriate). A UniFi access point will be installed (this is in stock). | + | On the long wall: |
- | ===== Benches and storage | + | * Many of ~290cm x 30cm (general |
+ | * ~290cm x 25-30cm (for oscilloscope, | ||
- | Proposed: 75-80cm benches against | + | To the right of the sink, attached to wall and sink unit: |
- | Discussions ongoing. | + | * Recessed shelf for PCB etch tank. |