g14_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
g14_setup [2019-07-06 13:30] – [Access control] alfie | g14_setup [2019-08-08 09:36] – [Tasks] tim | ||
---|---|---|---|
Line 5: | Line 5: | ||
These tasks can be started now: | These tasks can be started now: | ||
+ | * Shelves (see below) | ||
* Order/ | * Order/ | ||
* Run 4 cat5 cables from G11 rack to G14 roof space | * Run 4 cat5 cables from G11 rack to G14 roof space | ||
- | * Install UniFi access point | + | * Sort/ |
- | * Order new legs for sink unit | + | * Clean ESD mats and trim to match worktops |
+ | * Install louvre panels on short wall below conduit [1 done, 2 to go] | ||
- | ===== Access control | + | ===== Shelves |
- | <del>The door will be fitted with the same type of lock as used for G2 and G8. The lock is currently | + | The vertical brackets are installed but we will need to order more horizontals, |
- | Done! | + | On the narrow end of the room, above the component drawers: |
- | ===== Floor ===== | + | * 3 of 226cm x 30-31cm (slightly less than 226 to allow for the conduit). |
- | The floor has damage that will need to be filled. Then it can be painted or covered with vinyl (this is a more practical task than for G1 as the space is small and already empty). | + | To the left of the window: |
- | ESD flooring has been proposed but is likely to be expensive. We have a roll of ESD flooring but it is soft (anti-fatigue, designed | + | * 150cm x 54cm (for the function generator and HP power supply) |
+ | * 150cm x 25-30cm (for oscilloscope, | ||
- | ===== Networking ===== | + | On the long wall: |
- | Cables will be run from the server rack in G11 (2-4 would be appropriate). A UniFi access point will be installed | + | * Many of ~290cm x 30cm (general storage) |
+ | * ~290cm x 25-30cm | ||
- | ===== Benches | + | To the right of the sink, attached to wall and sink unit: |
- | Proposed: 75-80cm benches against the long walls of the room. No bench on the short ends (because corners are too restrictive). Use the short end (away from the door) for storage. Shelving over the benches (some mix of general storage and ready-to-use equipment). | + | * Recessed shelf for PCB etch tank. |
- | + | ||
- | Discussions ongoing. | + | |