g14_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
g14_setup [2019-08-10 17:56] – [Tasks] tim | g14_setup [2022-05-21 11:49] – river | ||
---|---|---|---|
Line 3: | Line 3: | ||
===== Tasks ===== | ===== Tasks ===== | ||
- | These tasks can be started now: | ||
- | |||
- | * Install shelf for PCB etch tank | ||
- | * < | ||
- | * Shelves (see below) | ||
- | * < | ||
* Run 4 cat5 cables from G11 rack to G14 roof space | * Run 4 cat5 cables from G11 rack to G14 roof space | ||
- | * Sort/tidy/prepare electronics | + | * Organise |
- | * Clean ESD mats and trim to match worktops | + | |
- | * < | + | |
- | * < | + | |
- | * Obtain some chairs (3-4, computer operator chairs or " | + | |
- | + | ||
- | ===== Shelves ===== | + | |
- | + | ||
- | The vertical brackets are installed but we will need to order more horizontals, | + | |
- | + | ||
- | On the narrow end of the room, above the component drawers: | + | |
- | + | ||
- | * 3 of 226cm x 30-31cm (slightly less than 226 to allow for the conduit). | + | |
- | + | ||
- | To the left of the window: | + | |
- | + | ||
- | * 150cm x 54cm (for the function generator and HP power supply) | + | |
- | * 150cm x 25-30cm (for oscilloscope, | + | |
- | + | ||
- | On the long wall: | + | |
- | + | ||
- | * Many of ~290cm x 30cm (general storage) | + | |
- | * ~290cm x 25-30cm (for oscilloscope, | + | |
- | + | ||
- | To the right of the sink, attached to wall and sink unit: | + | |
- | + | ||
- | * Recessed shelf for PCB etch tank. | + | |