Differences

This shows you the differences between two versions of the page.

--- lasercutter2 [2018-07-14 21:18] – [Guide for existing laser cutter users] alfie
+++ lasercutter2 [2018-07-14 21:20] – [Log] alfie
@@ Line 135: / Line 135: @@
   * pause the cutting session
-  * check the temperature on the chiller's front panel (it should be in the range 10-20C)
+  * check the temperature on the chiller's front panel (it should be in the range 10-23℃, roughly room temperature)
   * if the temperature is too high, try waiting for the chiller to bring the temperature down
   * if the temperature doesn't fall then there is probably a fault
@@ Line 167: / Line 167: @@
 -05-28:
   * Bed levelled.
+-07-14:
+  * New tinted window fitted: it is now safe to stare directly at the beam. Also at some point proper LED lighting was installed but wasn't logged.
 ===== Other Specifications (for maintenance) =====