lasercutter2
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
lasercutter2 [2018-07-14 21:48] – tim | lasercutter2 [2018-11-21 20:51] – tim | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Laser Cutter #2 ====== | ====== Laser Cutter #2 ====== | ||
- | NOT YET IN SERVICE. | + | TRAINING REQUIRED BEFORE USE.\\ |
- | (Note: | + | (Note: |
+ | |||
+ | HOURS OF USE ARE LIMITED TO **8PM-8AM** UNTIL ADDITIONAL FUME EXTRACTION HAS BEEN INSTALLED. | ||
Model JD90125\\ | Model JD90125\\ | ||
Line 10: | Line 12: | ||
{{: | {{: | ||
+ | |||
+ | |||
+ | ===== Safety ===== | ||
+ | |||
+ | There is always a fire risk when using the laser. The laser should not be left unattended during a cut. | ||
+ | |||
+ | Failure to pay attention to the laser can result in this: | ||
+ | |||
+ | {{: | ||
===== To Do ===== | ===== To Do ===== | ||
Line 168: | Line 179: | ||
2018-07-14: | 2018-07-14: | ||
* New tinted window fitted: it is now safe to stare directly at the beam. Also at some point proper LED lighting was installed but wasn't logged. | * New tinted window fitted: it is now safe to stare directly at the beam. Also at some point proper LED lighting was installed but wasn't logged. | ||
+ | |||
+ | 2018-07-19: | ||
+ | * The bed level was checked and it's within 1mm all over. The axes were checked and they' | ||
+ | |||
+ | 2018-09-22: | ||
+ | * Tube #2 (from Smoke and Mirrors) installed. All mirrors realigned to a reasonable (but not perfect) standard. | ||
===== Other Specifications (for maintenance) ===== | ===== Other Specifications (for maintenance) ===== | ||
Water tubing: silicone, 12mm OD, 8mm ID, 2mm wall\\ | Water tubing: silicone, 12mm OD, 8mm ID, 2mm wall\\ | ||
- | Chiller: CW-3000\\ | + | Chiller: CW-5200\\ |
Air assist compressor: Hailea ACO-328\\ | Air assist compressor: Hailea ACO-328\\ | ||
Air assist tubing: silicone, 12mm OD, 8mm ID, 2mm wall\\ | Air assist tubing: silicone, 12mm OD, 8mm ID, 2mm wall\\ | ||
Line 184: | Line 201: | ||
* {{ : | * {{ : | ||
* {{ : | * {{ : | ||
- | * {{ :cw-3000.pdf | CW-3000 Chiller Manual }} ({{ :cw-3000-2.pdf | alternative version | + | * {{ :cw-5000_5200_industrial_chiller_user_manual.pdf | CW-5200 Chiller Manual }} |
+ | * {{ :cw-5000_5200_industrial_chiller_maintenance_manual.pdf | CW-5200 Maintenance Manual | ||
* {{ : | * {{ : | ||
* {{ : | * {{ : |
lasercutter2.txt · Last modified: 2024-08-26 19:42 by danshearer