Differences

This shows you the differences between two versions of the page.

--- lasercutter2 [2020-08-08 18:59] – [Log] costa
+++ lasercutter2 [2021-11-24 11:54] – [Log] simon
@@ Line 41: / Line 41: @@
 | MDF 6mm | 10 | 100 | Miron |
 | Paper |  |  |  |
-| Card |  |  |  |
+| Card (200gsm) | 40-55 | 30 | Scott |
+| Card fold line (200gsm) | 100 | 30 | Scott |
 | Engraving Laminate 1.5mm | 50 | 100 | Miron |
 | Engraving Laminate 3mm |  |  |  |
@@ Line 50: / Line 51: @@
 | MDF | 350 | 50 | Miron |
 | Laminate | 350 | 50 | Miron |
+| Card (200gsm) | 500 | 30 | Scott |
 Minimum power setting for the laser to turn on: 19
@@ Line 223: / Line 225: @@
 -08-08:
   * The mirrors were realigned, the actual laser tube was sitting about 2mm too low and the field was slightly crooked with the top right corner shooting too high. It seems to that the body of the laser had bent back to its original geometry from the time we've got the laser in 2018. It has probably happened due to the different location and maybe better floor. The intermittent issue of the tube switching off could not be replicated, the HV wires were checked but no obvious burn or oxidation marks have been identified.
+-08-05:
+  * "I recently found that pressing the arrow buttons would only "jog" it by a centimetre at a time and I couldn't get it to move continuously while holding it down" (Julian)
+  * "I think the wire harness for the Y axis is troublesome. I think the motor wires are still fine but the limit switch is dead. Also - after jiggerypockering the X axis limit switch wire the issue describes by Julian has gone (it shouldn't but it did). I suggest we get good quality silicone wires, the AWG22 for all signal stuff and 4way  AWG 16-18 for the stepper motors (they are 2A so need more meat) and gather in a group of 2-3 members to rewire the motors, laser pointer and all the limit switches." (Costa)
+-11-24:
+  * "Both Y and Z axes weren't moving - I spent a while with it tonight and figured out and fixed the Y axis - stepper driver wasn't getting power - but haven't been able to fix Z. It's not the same problem, Z driver is lighting up, it just won't move." (Julian)
 ===== Other Specifications (for maintenance) =====