lasercutter2
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| lasercutter2 [2019-05-14 11:31] – [Recommended Settings] mirza | lasercutter2 [2019-06-09 22:48] – [To Do] alfie | ||
|---|---|---|---|
| Line 93: | Line 93: | ||
| * < | * < | ||
| </ | </ | ||
| - | * Install ducts to roof and upgrade blower, to avoid releasing fumes onto courtyard users. **ACTION: | + | * Install ducts to roof and upgrade blower, to avoid releasing fumes onto courtyard users. **ACTION: |
| * < | * < | ||
| * Replace broken acrylic cover on front-loading slot. | * Replace broken acrylic cover on front-loading slot. | ||
| Line 140: | Line 140: | ||
| * position the material on the bed and move the nozzle over the material | * position the material on the bed and move the nozzle over the material | ||
| - | * release the locking ring on the nozzle | + | * release the locking ring on the nozzle |
| * place the 12mm focus jig between the nozzle and the material, and lower the nozzle down to touch it | * place the 12mm focus jig between the nozzle and the material, and lower the nozzle down to touch it | ||
| * if there isn't enough available movement of the nozzle, **remove the jig**, adjust the Z axis and try again | * if there isn't enough available movement of the nozzle, **remove the jig**, adjust the Z axis and try again | ||
| - | * re-secure the nozzle and remove the jig | + | * re-secure the nozzle and remove the jig (turn {{img_20190528_203219_01.jpg? |
| * check that the air assist is switched on and that the valve on the right-hand side is fully open | * check that the air assist is switched on and that the valve on the right-hand side is fully open | ||
| * the air assist may be reduced for delicate materials such as paper and card, but some air should be kept on to protect the lens from smoke | * the air assist may be reduced for delicate materials such as paper and card, but some air should be kept on to protect the lens from smoke | ||
lasercutter2.txt · Last modified: 2023-12-24 13:36 by simon