lasercutter2
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
lasercutter2 [2019-07-13 00:12] – DavidW | lasercutter2 [2019-07-23 22:32] – [To Do] mirza | ||
---|---|---|---|
Line 3: | Line 3: | ||
TRAINING REQUIRED BEFORE USE.\\ | TRAINING REQUIRED BEFORE USE.\\ | ||
(Note: Access control is ad-hoc, Ask someone to add you after you have received a walkthrough.) | (Note: Access control is ad-hoc, Ask someone to add you after you have received a walkthrough.) | ||
- | |||
- | HOURS OF USE ARE LIMITED TO **8PM-8AM** UNTIL ADDITIONAL FUME EXTRACTION HAS BEEN INSTALLED. | ||
Model JD90125\\ | Model JD90125\\ | ||
Line 63: | Line 61: | ||
* < | * < | ||
* < | * < | ||
- | * Create chart of power/speed settings for common materials (as a basic rule, multiply speeds from the old chart by 3x) | + | * <del>Create chart of power/speed settings for common materials (as a basic rule, multiply speeds from the old chart by 3x)</ |
- | * Ply ✔ | + | |
- | * MDF ✘ | + | |
- | * Acrylic ✘ | + | |
* < | * < | ||
* Update docs: | * Update docs: | ||
Line 80: | Line 75: | ||
* < | * < | ||
</ | </ | ||
- | * Create spare focus jigs (requires 12mm acrylic, or a new design) | + | * <del>Create spare focus jigs (requires 12mm acrylic, or a new design)</ |
* Build and install monitoring system (laser usage, temperature logging) | * Build and install monitoring system (laser usage, temperature logging) | ||
* < | * < | ||
Line 93: | Line 88: | ||
* < | * < | ||
</ | </ | ||
- | * Install ducts to roof and upgrade blower, to avoid releasing fumes onto courtyard users. **ACTION: PETE** | + | * <del>Install ducts to roof and upgrade blower, to avoid releasing fumes onto courtyard users.</ |
* < | * < | ||
* Replace broken acrylic cover on front-loading slot. | * Replace broken acrylic cover on front-loading slot. | ||
Line 163: | Line 158: | ||
* check that the rear access panel (laser power supply) is closed properly | * check that the rear access panel (laser power supply) is closed properly | ||
* check that the access controller is logged-in | * check that the access controller is logged-in | ||
+ | |||
+ | ==== Nozzle quickly " | ||
+ | In LaserCut 5.3, File> | ||
+ | Make sure "Quick speed" is set to a sensible value like 300, work-acc to 500 and space-acc to 500 | ||
==== Nozzle moves but doesn' | ==== Nozzle moves but doesn' |
lasercutter2.txt · Last modified: 2023-12-24 13:36 by simon