Differences

This shows you the differences between two versions of the page.

--- lasercutter2 [2019-07-23 22:32] – [To Do] mirza
+++ lasercutter2 [2020-03-04 16:37] – bart
@@ Line 28: / Line 28: @@
 | Acrylic 1mm | 30 | 40 | Miron |
 | Acrylic 2mm | 28 | 100 | Miron |
-| Acrylic 3mm | <del>18</del> 17 | 100 | Miron, David(18 wasn't fully cutting) |
+| Acrylic 3mm | 17 | 100 | David |
 | Acrylic 4mm | 15 | 100 | Miron |
 | Acrylic 5mm | 12 | 100 | Miron |
 | Acrylic 8mm | 4 | 100 | David |
 | Acrylic 10mm | 3 | 100 | Miron |
-| Ply 3mm | <del>30</del> 20 | 100 | <del>Miron</del> Simon |
+| Ply 3mm | 50 | 100 | Bart |
 | Ply 4mm | 20 | 100 | Miron |
 | Ply 6mm | 9 | 100 | Miron |
@@ Line 45: / Line 45: @@
 | Engraving Laminate 3mm |  |  |  |
-^ Material ^ Engrave Speed ^ (Range of) Engrave Power ^ Notes ^
+^ Material ^ Engrave Speed ^ Engrave Power ^ Notes ^
-| Acrylic |  |  |  |
+| Acrylic | 350 | 50 | Miron |
-| Ply |  |  |  |
+| Ply | 500 | 30 | Bart |
-| MDF |  |  |  |
+| MDF | 350 | 50 | Miron |
-| Laminate |  |  |  |
+| Laminate | 350 | 50 | Miron |
 Minimum power setting for the laser to turn on: 19
@@ Line 218: / Line 218: @@
   * Tube #2 (from Smoke and Mirrors) installed. All mirrors realigned to a reasonable (but not perfect) standard. Power level set to 33%.
+-03-03:
+  * Fettled the rear safety switch for the door to make it work reliably again.
 ===== Other Specifications (for maintenance) =====