lasercutter
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
lasercutter [2018-02-15 12:36] – [Uncut/unengraved sections & inconsistent cuts] More guff gone al | lasercutter [2018-03-26 00:12] – tim | ||
---|---|---|---|
Line 94: | Line 94: | ||
Download it again to the laser cutter. | Download it again to the laser cutter. | ||
- | ===== Acceptable temperature range of the water ===== | ||
- | |||
- | London Hackspace: 22 ± 3 °C (checked 24 June 2012) | ||
- | [[http:// | ||
- | The manual notes that you should change water if the temperature is higher than this degree. | ||
- | The temperature gets currently just measured on one point. The London Hackspace is currently monitoring the Laser cutter with coolbot but reports are reported. [[http:// | ||
===== Using Inkscape for lasering ===== | ===== Using Inkscape for lasering ===== | ||
Line 247: | Line 241: | ||
2017-12-16: | 2017-12-16: | ||
* Recalibrated power output: 36% = 9mA = 40W output. | * Recalibrated power output: 36% = 9mA = 40W output. | ||
+ | |||
+ | 2018-03-21: | ||
+ | * Laser cutter relocated to workbench. | ||
+ | * Water changed. | ||
+ | * Temperature sensors not currently available. | ||
+ | * Basic alignment check performed. | ||
===== Other Specifications (for maintenance) ===== | ===== Other Specifications (for maintenance) ===== |
lasercutter.txt · Last modified: 2023-12-24 13:37 by simon