lasercutter
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| lasercutter [2018-02-15 12:36] – [Uncut/unengraved sections & inconsistent cuts] More guff gone al | lasercutter [2018-04-29 02:13] – [Log] tim | ||
|---|---|---|---|
| Line 6: | Line 6: | ||
| Bed: 300x600mm\\ | Bed: 300x600mm\\ | ||
| Laser: 40W glass CO2 | Laser: 40W glass CO2 | ||
| + | |||
| + | See also: [[lasercutter2|Laser Cutter #2]] | ||
| ===== Materials ===== | ===== Materials ===== | ||
| Line 94: | Line 96: | ||
| Download it again to the laser cutter. | Download it again to the laser cutter. | ||
| - | ===== Acceptable temperature range of the water ===== | ||
| - | |||
| - | London Hackspace: 22 ± 3 °C (checked 24 June 2012) | ||
| - | [[http:// | ||
| - | The manual notes that you should change water if the temperature is higher than this degree. | ||
| - | The temperature gets currently just measured on one point. The London Hackspace is currently monitoring the Laser cutter with coolbot but reports are reported. [[http:// | ||
| ===== Using Inkscape for lasering ===== | ===== Using Inkscape for lasering ===== | ||
| Line 248: | Line 244: | ||
| * Recalibrated power output: 36% = 9mA = 40W output. | * Recalibrated power output: 36% = 9mA = 40W output. | ||
| + | 2018-03-21: | ||
| + | * Laser cutter relocated to workbench. | ||
| + | * Water changed. | ||
| + | * Temperature sensors not currently available. | ||
| + | * Basic alignment check performed. | ||
| + | |||
| + | 2018-04-11: | ||
| + | * Nozzle replaced (smaller aperture fitted) | ||
| + | |||
| + | 2018-04-28: | ||
| + | * Mike actually tightened the nozzle up properly, fixing reported alignment/ | ||
| ===== Other Specifications (for maintenance) ===== | ===== Other Specifications (for maintenance) ===== | ||
lasercutter.txt · Last modified: 2023-12-24 13:37 by simon