lasercutter
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
lasercutter [2018-07-19 16:06] – [Log] mike | lasercutter [2019-07-18 10:31] – [Laser Cutter] tim | ||
---|---|---|---|
Line 7: | Line 7: | ||
Laser: 40W glass CO2 | Laser: 40W glass CO2 | ||
- | {{: | + | {{: |
See also: [[lasercutter2|Laser Cutter #2]] | See also: [[lasercutter2|Laser Cutter #2]] | ||
Line 23: | Line 23: | ||
Engraving of some coated metals is possible, Martin has documented his experiences of [[engravingaluminium|engraving anodised aluminium]]. | Engraving of some coated metals is possible, Martin has documented his experiences of [[engravingaluminium|engraving anodised aluminium]]. | ||
+ | |||
+ | ===== Safety ===== | ||
+ | |||
+ | There is always a fire risk when using the laser. The laser should not be left unattended during a cut. | ||
+ | |||
+ | Failure to pay attention to the laser can result in this: | ||
+ | |||
+ | {{: | ||
===== Prices ===== | ===== Prices ===== | ||
Line 28: | Line 36: | ||
Usage is charged by cutting time: £5 per hour for members, £15 per hour for non-members. You don't need to pay for a full hour if you don't use it. | Usage is charged by cutting time: £5 per hour for members, £15 per hour for non-members. You don't need to pay for a full hour if you don't use it. | ||
- | Materials cost between £1.50 (3mm MDF) and £13 (6mm acrylic), per 300x660mm | + | Materials cost between £1.50 (3mm MDF) and £13 (6mm acrylic), per 300x600mm |
===== Power Levels ===== | ===== Power Levels ===== | ||
Line 260: | Line 268: | ||
2018-07-19: | 2018-07-19: | ||
* Mike re-calibrated the axes. Previously they were off by 1mm over 260mm in Y and 0.5mm over 180mm in X. | * Mike re-calibrated the axes. Previously they were off by 1mm over 260mm in Y and 0.5mm over 180mm in X. | ||
+ | |||
+ | 2018-08-??: | ||
+ | |||
+ | * DIY chiller failed and was replaced with old ambient cooler from big laser. Seems to be keeping up with normal cutting/ | ||
+ | |||
+ | 2019-04-27: | ||
+ | * Laser hour-meter removed (718 hours on the clock). | ||
+ | * Tool access controller installed. | ||
+ | |||
===== Other Specifications (for maintenance) ===== | ===== Other Specifications (for maintenance) ===== | ||
Line 275: | Line 292: | ||
* [[http:// | * [[http:// | ||
* [[http:// | * [[http:// | ||
+ | * {{ : | ||
{{tag> | {{tag> |
lasercutter.txt · Last modified: 2023-12-24 13:37 by simon