lasercutter_tips_and_tricks
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
lasercutter_tips_and_tricks [2019-11-03 18:11] – [Techniques] Added templatemaker.nl al | lasercutter_tips_and_tricks [2020-01-14 17:24] – [Techniques] MirZa | ||
---|---|---|---|
Line 37: | Line 37: | ||
* The edges of the thin [[https:// | * The edges of the thin [[https:// | ||
* It might give a better result if cutting with multiple passes at lower power | * It might give a better result if cutting with multiple passes at lower power | ||
+ | |||
+ | **Glass** | ||
+ | *Glass can't be cut on the laser, but it can be " | ||
+ | *Engraving: https:// | ||
+ | *Engraving lines can be used to score glass for cutting https:// | ||
**Food** | **Food** | ||
Line 98: | Line 103: | ||
* Switch the 2 copies around | * Switch the 2 copies around | ||
* run the engrave again | * run the engrave again | ||
+ | |||
+ | **Rotary Axis** | ||
+ | *The Big laser has a rotary attachment for engraving and cutting cylindrical objects | ||
+ | *To use it: | ||
+ | *lower the bed of the laser down until you can see 2 switches and a socket on the right wall of the cutting area | ||
+ | *bring the laser head to roughly the centre of the bed | ||
+ | *plug in the rotary axis and flick both switches, this changes the laser from controlling the up/down motor to controlling the rotary axis motor | ||
+ | *cutting and engraving is done exactly the same as before, you may need to adjust the vertical scaling to get a nice result | ||
+ | *when you're done, don't forget to return the laser to the state you found it in | ||
**Making rigid material flexible with living hinges** | **Making rigid material flexible with living hinges** | ||
Line 115: | Line 129: | ||
* TODO: insert image | * TODO: insert image | ||
+ | **Acrylic bending** | ||
+ | * Can be done with hair straightener or hot air gun | ||
+ | * Costa has made a nice jig for bending acrylic at precise angles, consisting of nichrome wire, 2 board boards and a hinge https:// | ||
+ | * This can also be done on the laser, using an out of focus beam or with the lens removed https:// | ||
===== Design ===== | ===== Design ===== | ||
**Removing duplicate lines** | **Removing duplicate lines** |
lasercutter_tips_and_tricks.txt · Last modified: 2023-12-20 23:47 by danshearer