Differences

This shows you the differences between two versions of the page.

--- prusa_i3_mk_3 [2018-12-19 01:08] – created mirza
+++ prusa_i3_mk_3 [2022-05-16 19:53] – simon
@@ Line 1: / Line 1: @@
-====== Original Prusa i3 MK3 ======
+====== Original Prusa i3 MK3s ======
-Miron Zadora is lending his printer to the hacklab
+Miron Zadora is lending his printer to the lab
 ===== Costs =====
@@ Line 34: / Line 34: @@
 ===== Software =====
-You can use two different slicers with the Prusa.
+[[https://www.prusa3d.com/prusaslicer/|PrusaSlicer]] - very user friendly, has a simple and an expert mode, suited for new and experienced users alike
-  * [[https://www.prusa3d.com/slic3r-prusa-edition/|Slic3r]] - Slic3r Prusa edition is the more advanced version that allows a lot more control but can be overwhelming for a new user.
-  * [[https://prusacontrol.org/|PrusaControl]] - PrusaControl is a very simple slicer that is great for beginners.
 If you wish to use a different slicer you can ask on the mailing list. But unless you have a very good reason to use a different one it's advised to stick with the listed options.
@@ Line 45: / Line 40: @@
 ===== Calibration =====
-The Prusa MK3 will automatically calibrate before every print.\\
+The Prusa MK3s will automatically calibrate before every print.\\
 Do not use the calibration option on your own without a previous discussion on the mailing list.\\
-Different materials require different Z-offsets. If you change the Z-offset, make sure to change it back to the previous setting.
+Different materials may require different Z-offsets. If you want to change the Z-offset, make sure to first note down the previous setting and change it back when you're done.
 ===== Firmware =====
-Printer is using an unmodified version of the the original Prusa MK3 firmware. We have no intention of changing this.
+Printer is using an unmodified version of the the original Prusa MK3s firmware. We have no intention of changing this.
 ===== Printing Instructions =====
@@ Line 59: / Line 53: @@
 If you want some guidance here is a perfect quick start guide from Prusa Research: https://www.prusa3d.com/new-user-mk3/
+===== Revo RapidChange nozzles =====
+It's now possible to print more detailed or larger prints as the new
+nozzles can be quickly unscrewed by hand and swapping them takes less then
+a minute.
+The normal nozzle size is 0.4mm, and is marked with a RED cover. Make sure
+you have the correct one installed before starting a print and please swap
+back to 0.4 when you're finished with a differently sized one
+We currently have 0.25, 0.4, 0.6 and 0.8mm brass nozzles, hopefully
+hardened ones for abrasive materials will be released later.
+  * https://e3d-online.com/products/revo-nozzles
+  * https://www.youtube.com/watch?v=-wy4IUbpVgA
 ===== Documentation =====