Differences

This shows you the differences between two versions of the page.

--- startrite_bandsaw [2019-06-09 16:23] – Started the log alfie
+++ startrite_bandsaw [2021-01-17 22:58] – [Specs] MirZa
@@ Line 10: / Line 10: @@
   * Drive belt: 50" external / 48" internal A-section V-belt
+Laser cuttable design for the acrylic piece that goes in the centre of the table, 8-9mm thick: {{ :startrite_bandsaw_cutout.dxf | startrite_bandsaw_cutout.dxf }}
 ===== TODO =====
   * Install dust collection
@@ Line 104: / Line 105: @@
   * Blade speed too fast, and/or blade pitch too coarse.
   * Insufficient blade tension.
 ===== Trainers & Maintainers =====
@@ Line 109: / Line 111: @@
   * Cameron Sharp (cazagen)
-  * Alfie Pates (alfie)
   * Mike Walters (miek)
@@ Line 115: / Line 116: @@
   * Cameron Sharp (cazagen)
   * Mike Walters (miek)
-  * Alfie Pates (alfie)
 ===== Log =====
@@ Line 122: / Line 121: @@
   * **01/01/1970** Template log entry. Copy this below. //Author//
   * **09/06/2019** Found tool in an unusable state. Blade tracking was completely out, blade falling off back of wheels. Guide bearings were also mis-adjusted - blade was being forced into them and making a very angry noise when pulled through by hand. Spent 45 minutes re-adjusting the blade tracking to get the blade running true again, re-adjusted blade tension and guide bearings. //Alfie//
+  * **07/12/2019** Found the blade blunt. Cameron replaced it with a new one. //Vytas//