tool_access_controllers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
tool_access_controllers [2019-03-03 22:26] – tim | tool_access_controllers [2019-04-27 18:35] – tim | ||
---|---|---|---|
Line 13: | Line 13: | ||
Current: | Current: | ||
- | * Clarke Bandsaw | ||
* Startrite Bandsaw | * Startrite Bandsaw | ||
* Bantam Lathe | * Bantam Lathe | ||
* EMCO Lathe | * EMCO Lathe | ||
+ | * Small Laser Cutter | ||
* Big Laser Cutter | * Big Laser Cutter | ||
* Mitre Saw | * Mitre Saw | ||
Line 22: | Line 22: | ||
* Sander | * Sander | ||
* Welder | * Welder | ||
+ | * CNC Router | ||
Planned: | Planned: | ||
- | * Small Laser Cutter | ||
- | * CNC Router | ||
* Bench grinder(s) | * Bench grinder(s) | ||
* Drill press(es) | * Drill press(es) | ||
Line 102: | Line 101: | ||
- Assemble the PCB (see earlier section). | - Assemble the PCB (see earlier section). | ||
- Solder wires to two push buttons and twist the wires for tidiness. **WHAT LENGTH?** | - Solder wires to two push buttons and twist the wires for tidiness. **WHAT LENGTH?** | ||
- | - Solder five jumper wires to a PN532 module and use hot glue to support the joints. The wires will be connected to VCC, SDA, SCL, GND and the reset pin. At the other end the female connectors should be removed from their plastic housing and re-inserted into a 5-way housing. **WHAT LENGTH?** | + | - Solder five jumper wires to a PN532 module and use hot glue to support the joints. The wires will be connected to VCC, SDA, SCL, GND and the RSTPDN (reset) pin. At the other end the female connectors should be removed from their plastic housing and re-inserted into a 5-way housing. **WHAT LENGTH? |
- Laser-cut a front-frame (3mm clear acrylic) and two support pieces (2mm clear acrylic). | - Laser-cut a front-frame (3mm clear acrylic) and two support pieces (2mm clear acrylic). | ||
- Place the frame inside the enclosure. Use it to mark the drill centres for the push buttons. | - Place the frame inside the enclosure. Use it to mark the drill centres for the push buttons. |
tool_access_controllers.txt · Last modified: 2023-09-10 09:11 by tim