voron_2_4_r2
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
voron_2_4_r2 [2023-09-28 16:43] – Added revo support jaso55555 | voron_2_4_r2 [2023-10-25 18:35] – [Changing Nozzle] simon | ||
---|---|---|---|
Line 102: | Line 102: | ||
* Start by unloading the current filament and then cooling down the hotend (increasing the part cooling fan speed can help this go quicker). | * Start by unloading the current filament and then cooling down the hotend (increasing the part cooling fan speed can help this go quicker). | ||
- | * Then raise the printhead off the bed to allow access to the nozzle. | + | * Then raise the printhead off the bed to allow access to the nozzle |
* Unscrew the nozzle gently and screw in the new one. | * Unscrew the nozzle gently and screw in the new one. | ||
Line 115: | Line 115: | ||
# [include revo-0.8.cfg] | # [include revo-0.8.cfg] | ||
- | * Hit save and restart | + | * Hit **save** at the top of the editor |
* Load filament and print as normal. Do make sure your slicer is updated to the correct nozzle size. | * Load filament and print as normal. Do make sure your slicer is updated to the correct nozzle size. | ||
* Once you're done with the different nozzle, please swap it back to the 0.4mm one. | * Once you're done with the different nozzle, please swap it back to the 0.4mm one. | ||
voron_2_4_r2.txt · Last modified: 2024-04-24 17:39 by jaso55555