Differences

This shows you the differences between two versions of the page.

--- voron_2_4_r2 [2023-09-28 16:43] – Added revo support jaso55555
+++ voron_2_4_r2 [2023-11-04 15:52] – [Materials] dan
@@ Line 9: / Line 9: @@
 ===== Materials =====
-Same policy as the [[prusa_i3_mk_3|Original Prusa i3 MK3s]], if your materials are allowed on there, you may use them here.
+Please speak to Jacob before using any filament not on this list.
-**ABS** - Please open the window and dangle the exhaust pipe outside for the duration of your print.
+==== PLA ====
+  * [[https://rigid.ink/|Rigidink]]
+  * [[https://hatchbox3d.com/|Hatchbox]]
+  * [[https://uk.rs-online.com/web/c/computing-peripherals/3d-printing-scanning/3d-printing-materials/|RS Pro]]
+  * [[https://amz3d.com/|AMZ3D]]
+  * [[https://colorfabb.com/|ColorFab]]
+  * [[https://www.sunlu.com/en-gb|SunLU]]
+  * [[https://prusament.com/materials/pla/|Prusament]]
+  * [[https://www.esun3d.com/|eSun]]
-**TPU/TPE** - Please use the alternate bed kept to the left of the printer, although this bed cannot be run above 60 degrees or the PET coating will be damaged.
+==== PETG ====
+  * [[https://rigid.ink/|Rigidink]]
+  * [[https://hatchbox3d.com/|Hatchbox]]
+==== ABS ====
+Please open the window and dangle the exhaust pipe outside for the duration of your print.
+==== TPU/TPE ====
+Please use the alternate bed kept to the left of the printer, although this bed cannot be run above 60 degrees or the PET coating will be damaged.
 ===== Rules =====
@@ Line 102: / Line 120: @@
   * Start by unloading the current filament and then cooling down the hotend (increasing the part cooling fan speed can help this go quicker).
-  * Then raise the printhead off the bed to allow access to the nozzle.
+  * Then raise the printhead off the bed to allow access to the nozzle (using Move after Home).
   * Unscrew the nozzle gently and screw in the new one.
@@ Line 115: / Line 133: @@
     # [include revo-0.8.cfg]  # Revo 0.8
-  * Hit save and restart at the top of the editor. **DO NOT TOUCH ANYTHING ELSE IN THE CONFIG FILE**
+  * Hit **save & restart** at the top of the editor (this is not available on a phone, you need to **save** and then **restart**). **DO NOT TOUCH ANYTHING ELSE IN THE CONFIG FILE**
   * Load filament and print as normal. Do make sure your slicer is updated to the correct nozzle size.
   * Once you're done with the different nozzle, please swap it back to the 0.4mm one.