3dscanner
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
3dscanner [2016-12-13 23:40] – [Log] martin | 3dscanner [2020-06-15 19:06] – [Software install] Stephane | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== 3D Scanner ====== | ||
- | We have a NextEngine 3D Scanner SD. Status: broken | ||
- | |||
- | ===== Software install ===== | ||
- | |||
- | - Download ScanStudio CORE 1.7.3 from www.nextengine.com/ | ||
- | - Download the Desktop 3D scanner drivers from support.nextengine.com and go to the download section and install. (local mirror: {{: | ||
- | - After save is complete, right click in installer and go to Properties | ||
- | - Then click on the Compatibility tab and check 'Run this program in compatibility mode for:" and set it to Windows XP SP3 and press OK | ||
- | - Now right click on the installer and select 'Run as administrator' | ||
- | - Proceed to install and make sure that the 3D Scanner driver box is unchecked (if it is checked, then proceed and just ignore the errors that might pop up) | ||
- | - ScanStudio will start with errors, but just close the software after it loads up | ||
- | - Copy the attached DLL ({{: | ||
- | * C:\Program Files(x86)\NextEngine\ScanStudio\Driver | ||
- | * C:\Program Files(x86)\NextEngine\ScanStudio\DLL | ||
- | - Run ScanStudio and plug in scanner | ||
- | |||
- | If installing on a 32-bit PC, please skip steps 7-9 | ||
- | |||
- | ==== Log ==== | ||
- | |||
- | 2015-11-18: | ||
- | * Laura & Random reported that the machine seemed to be broken | ||
- | |||
- | 2016-1-28: | ||
- | * Mike opened it up and found that there is an unknown fault on the power supply board - similar to its initial fault. | ||
- | |||
- | 2016-12-13: | ||
- | * Martin has fixed the power supply fault. |
3dscanner.txt · Last modified: 2020-06-15 19:09 by tim