====== Juki DLN-415-2 Industrial Sewing Machine ======
====== Ask Jacob for training ======

HIGH SPEED, SINGLE NEEDLE, NEEDLE FEED.\\
LOCKSTITCH INDUSTRIAL SEWING MACHINE\\
EQUIPPED WITH AN AUTOMATIC UNDERTRIMMER\\

Owner: Jacob\\
Location: G14\\
State: Functioning, but lacks proper access control/bells and whistles


==== To-do list! ====
  * <del>Reassemble</del>
  * Fully clean
  * <del>Get missing screws for Feed Dog (Potentially feed dog cover screws too)</del>
     * <del>Feed Dog - Screw 1/8-44 L=6.4 * 2</del>
     * <del>Feed Dog Cover - Screw 11/64-40 L=8 .5 * 2</del>
  * <del>Get new oil</del>
  * <del>Build new spool holder (Spool rack too)</del>
  * <del>Learn to use</del> + write documentation

==== Ideas for future ====
  * Access control, for safety + training reasons'
     * We need new boards, however we may need a bigger relay as the standard ones are 10A, and the machine can run up to 13A
<del>  * Modern speed controller for motor
     * The type of motor we have is a [[https://en.wikipedia.org/wiki/AC_motor#Permanent-split_capacitor_motor|Permanent Split Capacitor motor]] so we'd need a VFD for best control, a voltage divider could work too but not as well.</del> **Not needed, but instead I should adjust the motor so it's easier to run at slow speeds**
  * Motor brake
     * In theory not needed, as the machine only operates when the belt is engaged with the motor, but the motor does keep spinning for a while when off.
  * Reverse engineer snipping mechanism
     * I'm pretty sure it's just an actuator, and I think the wires are broken out? It //should// be as simple as sending some juice down the line. We should map that to a button instead of the intended mechanism (Full pedal press)

==== Documents ====
Manual -> {{ ::ddl5522.pdf |}}\\
Usage Manual -> {{ ::juki_dln-415_better_usage_manual.pdf |}}\\
Parts List -> {{ ::juki_dln-415-partslist.pdf |}}