This is an old revision of the document!

Denford Novamill

Open VR Milling v5
(If you are introducing a new tool) New tool→ Post Processor → Number = The variable you have used at the post-processing stage of the Fusion 360. Enter a small description of the tool
Turn red switch to turn on the machine (It is below the desk)
(For wood) Use special vice.
- Select vice rouch selection of clamping.
- Attach vice fasteners on bed and vice. The connecting material ideally should be parallel with the earth maybe slightly higher on the screw side
- Then press vice grip of wood with the screws
Home - xyz → Jog (to the the offset
- Arrow keys allow you to move around the endmill position
- Set override to 100% with knobs.
Down left → Set offsets → Tooling ?? → Set tool
- For one tool don’t set diameter etc. This is not the case if you have multiple endmills
- Click change tool
- Attach the holder to the machine:
  - Remove the cap
  - Unscrew screw
  - The fastener should go at the middle of the opening
  - Clean holder& slot before attaching it
Work offsets (Find ‘0’ point)
- For low precision you need to start the spindle and jog it as soon as it is cutting
- Control panel → Job → Set spindle speed → Hit play
- Tool & offset → Set X or Y
- Add half the diameter of the tool
- Check the value @ the control panel
- For z do the same
File → Open → Select the fnc file
Control - Auto
Close water pump so that only air comes out