User Tools

Site Tools


g14_setup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
g14_setup [2019-08-08 09:38]
tim [Tasks]
g14_setup [2019-08-31 22:20]
tim [Tasks]
Line 5: Line 5:
 These tasks can be started now: These tasks can be started now:
  
 +  * <​del>​Install shelf for PCB etch tank</​del>​
 +  * <​del>​Deep shelf for PSU and function generator</​del>​
   * Shelves (see below)   * Shelves (see below)
-  * Order/​source a combined euro-profile and handle for door.+  * <del>Order/​source a combined euro-profile and handle for door.</​del>​
   * Run 4 cat5 cables from G11 rack to G14 roof space   * Run 4 cat5 cables from G11 rack to G14 roof space
   * Sort/​tidy/​prepare electronics components for the move   * Sort/​tidy/​prepare electronics components for the move
-  * Clean ESD mats and trim to match worktops +  * <del>Clean ESD mats and trim to match worktops</​del>​ 
-  * Install louvre panels on short wall below conduit [1 done, 2 to go] +  * <del>Install louvre panels on short wall below conduit [1 done, 2 to go]</​del>​ 
-  * Steal the worktop that currently covers the 2nd sink in G1. Cut it to make a 150x55cm shelf.+  * <del>Steal the worktop that currently covers the 2nd sink in G1. Cut it to make a 150x55cm shelf.</​del>​ 
 +  * Obtain some chairs (3-4, computer operator chairs or "​guest"​ chairs)
  
 ===== Shelves ===== ===== Shelves =====
Line 23: Line 26:
 To the left of the window: To the left of the window:
  
-  * 150cm x 54cm (for the function generator and HP power supply)+  * <​del> ​150cm x 54cm (for the function generator and HP power supply) ​</​del>​
   * 150cm x 25-30cm (for oscilloscope,​ soldering tools, etc)   * 150cm x 25-30cm (for oscilloscope,​ soldering tools, etc)
  
g14_setup.txt · Last modified: 2019-08-31 22:21 by tim