Differences

This shows you the differences between two versions of the page.

--- g14_setup [2019-08-09 18:59] – [Tasks] tim
+++ g14_setup [2019-08-31 22:21] – [Shelves] tim
@@ Line 5: / Line 5: @@
 These tasks can be started now:
-  * Install shelf for PCB etch tank
+  * <del>Install shelf for PCB etch tank</del>
-  * Deep shelf for PSU and function generator
+  * <del>Deep shelf for PSU and function generator</del>
   * Shelves (see below)
-  * Order/source a combined euro-profile and handle for door.
+  * <del>Order/source a combined euro-profile and handle for door.</del>
   * Run 4 cat5 cables from G11 rack to G14 roof space
   * Sort/tidy/prepare electronics components for the move
-  * Clean ESD mats and trim to match worktops
+  * <del>Clean ESD mats and trim to match worktops</del>
   * <del>Install louvre panels on short wall below conduit [1 done, 2 to go]</del>
-  * Steal the worktop that currently covers the 2nd sink in G1. Cut it to make a 150x55cm shelf.
+  * <del>Steal the worktop that currently covers the 2nd sink in G1. Cut it to make a 150x55cm shelf.</del>
   * Obtain some chairs (3-4, computer operator chairs or "guest" chairs)
@@ Line 26: / Line 26: @@
 To the left of the window:
-  * 150cm x 54cm (for the function generator and HP power supply)
+  * <del> 150cm x 54cm (for the function generator and HP power supply) </del>
-  * 150cm x 25-30cm (for oscilloscope, soldering tools, etc)
+  * <del>150cm x 25-30cm (for oscilloscope, soldering tools, etc)</del>
 On the long wall:
@@ Line 36: / Line 36: @@
 To the right of the sink, attached to wall and sink unit:
-  * Recessed shelf for PCB etch tank.
+  * <del>Recessed shelf for PCB etch tank</del>.