Differences

This shows you the differences between two versions of the page.

--- heating [2024-11-23 16:11] – simon
+++ heating [2025-02-16 20:03] (current) – [TODO] aria
@@ Line 3: / Line 3: @@
 ===== Using =====
-The G1, G2 and G14 heater thermostat can be set from the control panel or mqtt.
+The G1, G2 and G14 heater thermostat can be set from the control panel or mqtt. Setting a higher temperature will not make the room heat up faster.
 There is also central heating from Summerhall, which is switched on rarely. Panels are above the windows of G1, and above the test gear in G14. It can by adjusted with the knobs.
+[[https://grafana.ehlab.uk/d/ce4wm9q7dwveoc/heating|Dashboard]]
 ===== Implementation Details =====
-The electric heaters in G1, G2 and G8 are controlled by multiple WiFi switched sockets. Room temperature is determined by the wireless sensor with DS18B20, LDR, and two AA batteries on the G1 table, the thermostat is a python script at ehl-vm-things:/srv/docker/py3scripts/scripts/thermostat.
+The electric heaters in G1, G2 and G8 are switched by multiple WiFi sockets. Room temperature is determined by the LoRaWAN connected environment sensors (ehl-vm-things:/srv/docker/py3scripts/scripts/co2-sensors), or in G1 the sensor on the table (with DS18B20, LDR, and two AA batteries). Room presence is determined by the PIRs OR environment sensors (ehl-vm-things:/srv/docker/py3scripts/idle-monitor).
+The thermostat is a python script at ehl-vm-things:/srv/docker/py3scripts/scripts/thermostat.
 Target temperature can be changed by [[mqtt|MQTT Message Bus]] messages, which can be sent by the control panel in G1, or by your computer.
@@ Line 17: / Line 21: @@
 ===== TODO =====
-  * Put plug stats into Grafana
+  * Fan heater boost mode
   * Warn when the heater power is set too high and turn the plug off
+  * Repair the G2 PIR
+  * Repair the G14 PIR
+  * Stop using cloud-based temperature and presence detection
 ==== Example Stats ====