Differences

This shows you the differences between two versions of the page.

--- heating [2024-12-02 23:59] – [TODO] simon
+++ heating [2025-02-16 20:03] (current) – [TODO] aria
@@ Line 11: / Line 11: @@
 ===== Implementation Details =====
-The electric heaters in G1, G2 and G8 are controlled by multiple WiFi switched sockets. Room temperature is determined by the environment sensors (ehl-vm-things:/srv/docker/py3scripts/scripts/co2-sensors) <del>wireless sensor with DS18B20, LDR, and two AA batteries on the G1 table</del>. Room presence is determined by the PIRs OR environment sensors (ehl-vm-things:/srv/docker/py3scripts/idle-monitor).
+The electric heaters in G1, G2 and G8 are switched by multiple WiFi sockets. Room temperature is determined by the LoRaWAN connected environment sensors (ehl-vm-things:/srv/docker/py3scripts/scripts/co2-sensors), or in G1 the sensor on the table (with DS18B20, LDR, and two AA batteries). Room presence is determined by the PIRs OR environment sensors (ehl-vm-things:/srv/docker/py3scripts/idle-monitor).
 The thermostat is a python script at ehl-vm-things:/srv/docker/py3scripts/scripts/thermostat.
@@ Line 21: / Line 21: @@
 ===== TODO =====
-  * QR codes to turn the heating on/off in G2/G14
+  * Fan heater boost mode
-  * Show current temperature on the control panel by subscribing to MQTT using a WebSocket
-  * Add temperature target charges to #things discord channel
   * Warn when the heater power is set too high and turn the plug off
-  * Contactor-based control of the 2kW heaters in G1
+  * Repair the G2 PIR
-    * Use G1 500W heaters in for G2/G14
+  * Repair the G14 PIR
-    * Repurpose plugs for soldering irons
+  * Stop using cloud-based temperature and presence detection
 ==== Example Stats ====