heating
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| heating [2024-12-05 13:09] – simon | heating [2025-02-16 20:03] (current) – [TODO] aria | ||
|---|---|---|---|
| Line 21: | Line 21: | ||
| ===== TODO ===== | ===== TODO ===== | ||
| - | * QR codes to turn the heating on/off in G2/G14 | + | * Fan heater boost mode |
| - | * Show current temperature on the control panel by subscribing to MQTT using a WebSocket | + | |
| - | * < | + | |
| * Warn when the heater power is set too high and turn the plug off | * Warn when the heater power is set too high and turn the plug off | ||
| - | * <del>Repair the G1 temperature sensor</ | + | * Repair the G2 PIR |
| * Repair the G14 PIR | * Repair the G14 PIR | ||
| * Stop using cloud-based temperature and presence detection | * Stop using cloud-based temperature and presence detection | ||
| - | * Contactor-based control of the 2kW heaters in G1 (this may not work well because people won't like 2kW of heat right next to them even if it's required to maintain the room temperature -Simon) | ||
| - | * Use G1 500W heaters in for G2/G14 | ||
| - | * Repurpose plugs for soldering irons | ||
| ==== Example Stats ==== | ==== Example Stats ==== | ||
heating.1733404169.txt.gz · Last modified: 2024-12-05 13:09 by simon