lasercutter2
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
lasercutter2 [2019-07-23 22:46] – [Recommended Settings] mirza | lasercutter2 [2020-04-28 16:55] – [Recommended Settings] MirZa | ||
---|---|---|---|
Line 33: | Line 33: | ||
| Acrylic 8mm | 4 | 100 | David | | | Acrylic 8mm | 4 | 100 | David | | ||
| Acrylic 10mm | 3 | 100 | Miron | | | Acrylic 10mm | 3 | 100 | Miron | | ||
- | | Ply 3mm | <del>30</ | + | | Ply 3mm | 30 | 100 | Miron - cuts simple things fine at speed 50, but stutters when cutting curves. 30 is safer | |
| Ply 4mm | 20 | 100 | Miron | | | Ply 4mm | 20 | 100 | Miron | | ||
| Ply 6mm | 9 | 100 | Miron | | | Ply 6mm | 9 | 100 | Miron | | ||
Line 47: | Line 47: | ||
^ Material ^ Engrave Speed ^ Engrave Power ^ Notes ^ | ^ Material ^ Engrave Speed ^ Engrave Power ^ Notes ^ | ||
| Acrylic | 350 | 50 | Miron | | | Acrylic | 350 | 50 | Miron | | ||
- | | Ply | 350 | 50 | Miron | | + | | Ply | 500 | 30 | Bart | |
| MDF | 350 | 50 | Miron | | | MDF | 350 | 50 | Miron | | ||
| Laminate | 350 | 50 | Miron | | | Laminate | 350 | 50 | Miron | | ||
Line 218: | Line 218: | ||
* Tube #2 (from Smoke and Mirrors) installed. All mirrors realigned to a reasonable (but not perfect) standard. Power level set to 33%. | * Tube #2 (from Smoke and Mirrors) installed. All mirrors realigned to a reasonable (but not perfect) standard. Power level set to 33%. | ||
+ | 2020-03-03: | ||
+ | * Fettled the rear safety switch for the door to make it work reliably again. | ||
===== Other Specifications (for maintenance) ===== | ===== Other Specifications (for maintenance) ===== | ||
lasercutter2.txt · Last modified: 2023-12-24 13:36 by simon