lasercutter_tips_and_tricks
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| lasercutter_tips_and_tricks [2023-12-20 23:44] – Fix typo in commandline danshearer | lasercutter_tips_and_tricks [2023-12-20 23:47] (current) – Add Linux imagemagick info danshearer | ||
|---|---|---|---|
| Line 87: | Line 87: | ||
| * Steps: | * Steps: | ||
| * Dither an image in Gimp or this online tool https:// | * Dither an image in Gimp or this online tool https:// | ||
| - | * use Gimp or ms paint to convert the image to a monochrome bitmap, alternatively imagemagick using: **magick.exe in.png -monochrome -alpha off out.png** | + | * use Gimp or ms paint to convert the image to a monochrome bitmap, alternatively imagemagick using: **magick.exe in.png -monochrome -alpha off out.png** |
| * open the image in LaserCut and scale it so one pixel corresponds to one line of the laser engrave (the height of the image in mm should equal the height of the image in pixels multiplied by the scan gap) | * open the image in LaserCut and scale it so one pixel corresponds to one line of the laser engrave (the height of the image in mm should equal the height of the image in pixels multiplied by the scan gap) | ||
| * You can preview the output by clicking on " | * You can preview the output by clicking on " | ||
lasercutter_tips_and_tricks.txt · Last modified: 2023-12-20 23:47 by danshearer