Differences

This shows you the differences between two versions of the page.

--- prusa_i3_mk_3 [2018-12-19 01:08] – created mirza
+++ prusa_i3_mk_3 [2019-09-22 15:27] – [Software] MirZa
@@ Line 1: / Line 1: @@
 ====== Original Prusa i3 MK3 ======
-Miron Zadora is lending his printer to the hacklab
+Miron Zadora is lending his printer to the lab
 ===== Costs =====
@@ Line 34: / Line 34: @@
 ===== Software =====
-You can use two different slicers with the Prusa.
+[[https://www.prusa3d.com/prusaslicer/|PrusaSlicer]] - very user friendly, has a simple and an expert mode, suited for new and experienced users alike
-  * [[https://www.prusa3d.com/slic3r-prusa-edition/|Slic3r]] - Slic3r Prusa edition is the more advanced version that allows a lot more control but can be overwhelming for a new user.
-  * [[https://prusacontrol.org/|PrusaControl]] - PrusaControl is a very simple slicer that is great for beginners.
 If you wish to use a different slicer you can ask on the mailing list. But unless you have a very good reason to use a different one it's advised to stick with the listed options.
@@ Line 48: / Line 43: @@
 Do not use the calibration option on your own without a previous discussion on the mailing list.\\
-Different materials require different Z-offsets. If you change the Z-offset, make sure to change it back to the previous setting.
+Different materials may require different Z-offsets. If you want to change the Z-offset, make sure to first note down the previous setting and change it back when you're done.
 ===== Firmware =====