prusa_i3_mk_3
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
prusa_i3_mk_3 [2018-12-19 01:08] – [Original Prusa i3 MK3] mirza | prusa_i3_mk_3 [2019-09-22 15:27] – [Software] MirZa | ||
---|---|---|---|
Line 34: | Line 34: | ||
===== Software ===== | ===== Software ===== | ||
- | You can use two different slicers with the Prusa. | + | [[https:// |
- | + | ||
- | * [[https:// | + | |
- | + | ||
- | * [[https:// | + | |
If you wish to use a different slicer you can ask on the mailing list. But unless you have a very good reason to use a different one it's advised to stick with the listed options. | If you wish to use a different slicer you can ask on the mailing list. But unless you have a very good reason to use a different one it's advised to stick with the listed options. | ||
Line 48: | Line 43: | ||
Do not use the calibration option on your own without a previous discussion on the mailing list.\\ | Do not use the calibration option on your own without a previous discussion on the mailing list.\\ | ||
- | Different materials require different Z-offsets. If you change the Z-offset, make sure to change it back to the previous setting. | + | Different materials |
===== Firmware ===== | ===== Firmware ===== | ||
prusa_i3_mk_3.txt · Last modified: 2023-06-08 11:44 by simon