User Tools

Site Tools


prusa_i3_mk_3

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
prusa_i3_mk_3 [2019-06-24 15:07]
mirza [Calibration]
prusa_i3_mk_3 [2019-09-22 15:27]
MirZa [Software]
Line 34: Line 34:
 ===== Software ===== ===== Software =====
  
-You can use two different slicers with the Prusa. +[[https://www.prusa3d.com/prusaslicer/|PrusaSlicer]] - very user friendly, has a simple and an expert mode, suited for new and experienced users alike 
- +
-  * [[https://www.prusa3d.com/slic3r-prusa-edition/|Slic3r]] - Slic3r Prusa edition is the more advanced version that allows a lot more control but can be overwhelming for a new user+
- +
-  * [[https://prusacontrol.org/|PrusaControl]] - PrusaControl is very simple slicer that is great for beginners. +
  
 If you wish to use a different slicer you can ask on the mailing list. But unless you have a very good reason to use a different one it's advised to stick with the listed options. If you wish to use a different slicer you can ask on the mailing list. But unless you have a very good reason to use a different one it's advised to stick with the listed options.
Line 48: Line 43:
 Do not use the calibration option on your own without a previous discussion on the mailing list.\\ Do not use the calibration option on your own without a previous discussion on the mailing list.\\
  
-Different materials may require different Z-offsets. If you change the Z-offset, make sure to note down the previous setting and change it back when you're done.+Different materials may require different Z-offsets. If you want to change the Z-offset, make sure to first note down the previous setting and change it back when you're done.
 ===== Firmware ===== ===== Firmware =====
  
prusa_i3_mk_3.txt · Last modified: 2020-10-08 14:35 by MirZa