prusa_i3_mk_3
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
prusa_i3_mk_3 [2019-06-24 15:07] – [Calibration] mirza | prusa_i3_mk_3 [2020-10-08 14:35] – changed mk3 to mk3s MirZa | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Original Prusa i3 MK3 ====== | + | ====== Original Prusa i3 MK3s ====== |
Miron Zadora is lending his printer to the lab | Miron Zadora is lending his printer to the lab | ||
Line 34: | Line 34: | ||
===== Software ===== | ===== Software ===== | ||
- | You can use two different slicers with the Prusa. | + | [[https:// |
- | + | ||
- | * [[https:// | + | |
- | + | ||
- | * [[https:// | + | |
If you wish to use a different slicer you can ask on the mailing list. But unless you have a very good reason to use a different one it's advised to stick with the listed options. | If you wish to use a different slicer you can ask on the mailing list. But unless you have a very good reason to use a different one it's advised to stick with the listed options. | ||
Line 45: | Line 40: | ||
===== Calibration ===== | ===== Calibration ===== | ||
- | The Prusa MK3 will automatically calibrate before every print.\\ | + | The Prusa MK3s will automatically calibrate before every print.\\ |
Do not use the calibration option on your own without a previous discussion on the mailing list.\\ | Do not use the calibration option on your own without a previous discussion on the mailing list.\\ | ||
- | Different materials may require different Z-offsets. If you change the Z-offset, make sure to note down the previous setting and change it back when you're done. | + | Different materials may require different Z-offsets. If you want to change the Z-offset, make sure to first note down the previous setting and change it back when you're done. |
===== Firmware ===== | ===== Firmware ===== | ||
- | Printer is using an unmodified version of the the original Prusa MK3 firmware. We have no intention of changing this. | + | Printer is using an unmodified version of the the original Prusa MK3s firmware. We have no intention of changing this. |
===== Printing Instructions ===== | ===== Printing Instructions ===== |
prusa_i3_mk_3.txt · Last modified: 2023-06-08 11:44 by simon