Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
startrite_bandsaw [2019-06-15 14:14] – Notes on bandsaw alingment vzickus | startrite_bandsaw [2019-12-07 23:41] – [Log] vzickus |
---|
* Insufficient blade tension. | * Insufficient blade tension. |
| |
** Alignment:** | |
* Consult the manual/maintainers. | |
* For alignment geeks: [[https://www.youtube.com/watch?v=bxVyKsbuwZQ|Alignment by Snodgrass]] | |
===== Trainers & Maintainers ===== | ===== Trainers & Maintainers ===== |
| |
| |
* **01/01/1970** Template log entry. Copy this below. //Author// | * **01/01/1970** Template log entry. Copy this below. //Author// |
* **09/06/2019** Found tool in an unusable state. Blade tracking was completely out, blade falling off back of wheels. Guide bearings were also mis-adjusted - blade was being forced into them and making a very angry noise when pulled through by hand. Spent 45 minutes re-adjusting the blade tracking to get the blade running true again, re-adjusted blade tension and guide bearings. //Alfie// | * **09/06/2019** Found tool in an unusable state. Blade tracking was completely out, blade falling off back of wheels. Guide bearings were also mis-adjusted - blade was being forced into them and making a very angry noise when pulled through by hand. Spent 45 minutes re-adjusting the blade tracking to get the blade running true again, re-adjusted blade tension and guide bearings. //Alfie// |
| * **07/12/2019** Found the blade blunt. Cameron replaced it with a new one. //Vytas// |