Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision |
| startrite_bandsaw [2020-06-01 23:03] – [Trainers & Maintainers] alfie | startrite_bandsaw [2022-06-18 21:18] (current) – [Log] New blade mike |
|---|
| * Drive belt: 50" external / 48" internal A-section V-belt | * Drive belt: 50" external / 48" internal A-section V-belt |
| |
| | Laser cuttable design for the acrylic piece that goes in the centre of the table, 8-9mm thick: {{ :startrite_bandsaw_cutout.dxf | startrite_bandsaw_cutout.dxf }} |
| ===== TODO ===== | ===== TODO ===== |
| * Install dust collection | * Install dust collection |
| * **09/06/2019** Found tool in an unusable state. Blade tracking was completely out, blade falling off back of wheels. Guide bearings were also mis-adjusted - blade was being forced into them and making a very angry noise when pulled through by hand. Spent 45 minutes re-adjusting the blade tracking to get the blade running true again, re-adjusted blade tension and guide bearings. //Alfie// | * **09/06/2019** Found tool in an unusable state. Blade tracking was completely out, blade falling off back of wheels. Guide bearings were also mis-adjusted - blade was being forced into them and making a very angry noise when pulled through by hand. Spent 45 minutes re-adjusting the blade tracking to get the blade running true again, re-adjusted blade tension and guide bearings. //Alfie// |
| * **07/12/2019** Found the blade blunt. Cameron replaced it with a new one. //Vytas// | * **07/12/2019** Found the blade blunt. Cameron replaced it with a new one. //Vytas// |
| | * **18/06/2022** Fitted a new blade as the old one was blunt. //Mike// |
