todo
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| todo [2019-08-29 10:52] – [Small Tasks] tim | todo [2019-09-01 16:49] – [Small Tasks] tim | ||
|---|---|---|---|
| Line 10: | Line 10: | ||
| * G1 hifi shelves: replace the short brackets with long brackets (we have a surplus and the shelf would be more secure). | * G1 hifi shelves: replace the short brackets with long brackets (we have a surplus and the shelf would be more secure). | ||
| * Laser Cutter #1: Connect the air-flow sensor into the safety loop (in series with the lid switch, water flow sensor, etc). | * Laser Cutter #1: Connect the air-flow sensor into the safety loop (in series with the lid switch, water flow sensor, etc). | ||
| - | * Wire-up LEDs for one remaining tool locker. | + | * Move G6 (Al's room) access |
| - | * Secure tool locker LED wiring with hot glue (at the point where the wires meet the LED strip). | + | |
| - | * Install a locker controller and LED in the battery-charging compartment. | + | |
| ===== Bigger Tasks ===== | ===== Bigger Tasks ===== | ||
| Line 18: | Line 17: | ||
| These should be immediately actionable, describable in a single bullet point and take 1-3 hours for 1-2 people to complete: | These should be immediately actionable, describable in a single bullet point and take 1-3 hours for 1-2 people to complete: | ||
| - | * Pull < | + | * Pull additional Cat5 cables from between |
| - | * < | + | * Specify and purchase shelving for G14 (full-lengths, |
| + | * Install spur for G1 water heater. | ||
| + | * Tidy-up the radio corner. | ||
| ===== Infrastructure Projects ===== | ===== Infrastructure Projects ===== | ||
todo.txt · Last modified: 2022-07-04 19:30 by MirZa