bantam_lathe
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| bantam_lathe [2020-05-31 17:37] – [Risk Assessment (WIP)] jerome_woodwark | bantam_lathe [2024-08-27 00:42] (current) – [Log] mike | ||
|---|---|---|---|
| Line 70: | Line 70: | ||
| * 2016-10-26 - Lathe delivered | * 2016-10-26 - Lathe delivered | ||
| * 2016-10-31 - Spindle oil changed (~3L) & gearbox oil filled (~1.5L). Gearbox oil was almost empty so may need to monitor/ | * 2016-10-31 - Spindle oil changed (~3L) & gearbox oil filled (~1.5L). Gearbox oil was almost empty so may need to monitor/ | ||
| + | * 2023-06-29 - Topped up the spindle oil, it had dropped to the bottom edge of the sight glass. There is a slight leak from around the rear spindle bearing, but probably more effort than it's worth to investigate/ | ||
| + | * 2024-08-26 - Fitted adjustable screw foot & levelled the bed ways. Measured <10 um taper in 150 mm when cutting a test bar. | ||
bantam_lathe.1590946643.txt.gz · Last modified: 2020-05-31 17:37 by jerome_woodwark