User Tools

Site Tools


prusa_i3_mk_3

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
prusa_i3_mk_3 [2018-12-19 01:08]
mirza [Original Prusa i3 MK3]
prusa_i3_mk_3 [2019-09-22 15:27] (current)
MirZa [Software]
Line 34: Line 34:
 ===== Software ===== ===== Software =====
  
-You can use two different slicers with the Prusa. +[[https://​www.prusa3d.com/​prusaslicer/|PrusaSlicer]] - very user friendly, has a simple ​and an expert mode, suited ​for new and experienced users alike 
- +
-  * [[https://​www.prusa3d.com/​slic3r-prusa-edition/|Slic3r]] - Slic3r Prusa edition is the more advanced version that allows a lot more control but can be overwhelming for a new user+
- +
-  * [[https://​prusacontrol.org/​|PrusaControl]] - PrusaControl is very simple ​slicer that is great for beginners. +
  
 If you wish to use a different slicer you can ask on the mailing list. But unless you have a very good reason to use a different one it's advised to stick with the listed options. If you wish to use a different slicer you can ask on the mailing list. But unless you have a very good reason to use a different one it's advised to stick with the listed options.
Line 48: Line 43:
 Do not use the calibration option on your own without a previous discussion on the mailing list.\\ Do not use the calibration option on your own without a previous discussion on the mailing list.\\
  
-Different materials require different Z-offsets. If you change the Z-offset, make sure to change it back to the previous setting. +Different materials ​may require different Z-offsets. If you want to change the Z-offset, make sure to first note down the previous setting ​and change it back when you're done.
 ===== Firmware ===== ===== Firmware =====
  
prusa_i3_mk_3.1545181708.txt.gz · Last modified: 2018-12-19 01:08 by mirza