Differences

This shows you the differences between two versions of the page.

--- todo [2025-02-16 19:29] – aria
+++ todo [2025-02-16 21:03] (current) – [Bigger Tasks] aria
@@ Line 1: / Line 1: @@
 ====== To-Do (How can I help?) ======
-N.B. This page is neglected, and had not been edited for over two years at time of adding this comment.
 See also the [[members_nights|Members' Nights]] list.
@@ Line 9: / Line 7: @@
 These should be immediately actionable, describable in a single bullet point and take up to 30 minutes for one person to complete:
-  * Tidy and clear-out the kitchen cupboard. Should only contain cleaning supplies.
-  * G1 hifi shelves: replace the short brackets with long brackets (we have a surplus and the shelf would be more secure).
   * Sort out rails (shelf next to front of rack in G1) and store somewhere more convenient
+  * Design a test pattern for checking/calibrating the laser cutter
 ===== Bigger Tasks =====
@@ Line 18: / Line 14: @@
 These should be immediately actionable, describable in a single bullet point and take 1-3 hours for 1-2 people to complete:
-  * Pull additional Cat5 cables from between G11 and G14.
+  * Fix projector control
-  * Tidy-up the radio corner.
-  * Fix Volume control / MQTT-IR bridge
-  * Fix Projector control
-  * Fix air vent control in G1
   * Sort out spare tools (behind rack in G1) and make list on wiki somewhere
+  * Build a webapp to view [[http://spaceapi.net|Space API]] data
 ===== Infrastructure Projects =====
@@ Line 45: / Line 38: @@
 This schematic might help: http://rigol.codenaschen.de/index.php/Schematics
+=== Repair / Improve filament recycler  ===
+The filament recycler we used to use for [[plasticrecycling|plastic recycling]] is broken, and also not very good apparently. It should either be repaired or replaced.
 ===== Other Stuff =====
-  * Design a test pattern for checking/calibrating the laser cutter
-  * Build a webapp to view [[http://spaceapi.net|Space API]] data
 ===== Radio / Antenna TODO ====